Welded Wire Mesh

ADVANTAGES OF BRC Welded Wire Mesh

(1) Less steel required.

Due to higher working stress allowed in building codes, standard specifications for welded wire mesh made from cold drawn wire , a saving is made in steel purchased, transported. Handled and installed.

(2) Uniform steel distribution.

Welded wire mesh provides proper distribution of steel reinforcing throughout the concrete slab. It has smaller steel members that are closely and uniformly spaced, and accurately placed at all points of maximum stress. This typed of reinforcement distributes load stresses widely and equally throughout the concrete slab.

(3) Design requirements may be accurately fulfilled.

Welded wire mesh is available in a wide range of styles to meet accurate design requirements. The reinforcement is prefabricated in the factory, preventing omission or misplacement of steel in the fields.

(4) Quickly and economically placed.

No laying of single bars, cutting bending and knotting of single bars needed. A saving in installation labor expense is made possible by a reinforcement furnished to the job in sheets, which are easily and speedily placed in the desired position.


TECHNICAL DATA

RAW MATERIAL - Our steel wire rod is purchased from Hadeed Jubail (Saudi Iron and steel Co.) Being a part of the International Group of BRC. British reinforced concrete, testing are performed in our laboratory to ensure the quality supplied meets the highest international standards.

WIRE MESH - Our BRC mesh is manufactured to meet BS4483, DIN 488, ASTMA 185 AND 497. Our Quality Control Department is equipped with the latest electronic equipment to ensure these high standards are maintained throughout all stages of manufacture. Test certificates are issued on request the minimum tensile achieved to cover the above standers are:

Yield Strength - 500 N/mm2

Ultimate Strength - 550 N/mm2

WIRE DIANETTERS - 4 mm - 12 mm

SPECIAL SHEETS - Where the quantity is sufficient to justify an economical production run, we can produce sheets in any width up to 3.2 meters and in any length up to 12 meters.




APPLICATION

  • Reinforcing steel is necessary in practically all types of concrete construction. Concrete is weak in tension; consequently, reinforcement must be used to purpose because high yield strength cold-drawn wires of small size and close spacing can be combined to provide well distributed tensile reinforcement that is entirely adequate and economical .
Download PDF file for this Products



Address:

P.O.Box 5489 Jeddah 21422 Industrial Estate

Phone:

+966 12 6355666

Fax:

+966 12 6375474

E-mail:

brcsales@brc.com.sa

Contact Form